Industry Information

Update July 08, 2022

Operation process of film falling film evaporator

Operation process of film falling film evaporator The film falling film evaporator unit is composed of three parts of an evaporator, a vapor-liquid separator and a preheater, and a simple separator,...

Update July 07, 2022

Scraper type thin film evaporator performance and characteristics

The scraper-type thin film evaporator is a high-efficiency evaporation and distillation device that uses a high-speed rotation to distribute a liquid into a uniform film for evaporation or...

Update July 06, 2022

How to operate the alcohol recovery tower

Alcohol recovery tower operating procedures 1. Check if the equipment is clean before driving. 2. Check that each valve is in the correct opening and closing position. 3. Open the vacuum valve, and...

Update July 05, 2022

Determination of multi-effect evaporation effect

　　 In the process design, we should first consider the use of single-effect or multi-effect evaporation. In order to make full use of heat energy, multi-effect evaporation is generally used in...

Update July 04, 2022

Laboratory reaction kettle daily care operation precautions

1. In the reaction of different media in the reaction kettle, first check whether the medium has corrosion to the main material. The reaction to the moment is intense, a large amount of gas or a...

Update July 02, 2022

How to install and use the reaction kettle

How to install and use the reactor 1. It should be installed on a firm and level workbench. The height of the workbench is determined according to the use conditions. There should be a certain space...

Update July 01, 2022

Plastic heat exchanger can be applied sewage source heat pump energy-saving system

Sewage source heat pump is an efficient environmental protection and energy saving system. The particularity of wastewater quality makes the selection of heat exchanger equipment and the water...

Update June 30, 2022

Pros and Cons of Buried Tube Heat Exchanger in Ground Source Heat Pump System

Drilling depth less than 60m Drilling costs less, the cost is low, if more than 60m, the rig costs will increase; ② well depth of 80m, commonly used domestic pressure (pressure 1.0MPa) plastic pipe,...

Update June 29, 2022

Industrial chiller refrigeration heat exchanger introduction and analysis of heat transfer process

Industrial chiller refrigeration heat exchanger introduction and analysis of heat transfer process: We often say that the industrial chiller cooling heat exchanger, mainly refers to the condenser and...

Update June 28, 2022

Five measures to prevent foaming in diesel tanks

The air bubbles in the diesel engine tank are generally caused by high-pressure gas in the air cylinder that enters the cooling water channel. The cause of hernia is as follows: 1. The cylinder head...